产品介绍 Introduction
FS-iA8X 是一款专用于穿越机的单天线双向传输接收机,采
用了 AFHDS 2A(第二代增强版自动跳频数字系统)。它体
积小巧便于安装,可输出标准 PPM 信号和 i-BUS/S.BUS 信
号。
接收机概览 Receiver overview
Antenna
产品规格 Product specification
产品型号:FS-iA8X
适用机型:穿越机
无线频率:2.4GHz
无线协议:AFHDS 2A
天线类型:单天线
数据输出:PPM/i-BUS/S.BUS
输入电源:4.0 ~ 8.4V
温度范围:-15℃ -60℃
湿度范围:20%-95%
在线更新:无
外形尺寸:15*13*3mm
机身重量:1.1g
安规认证:CE,FCC ID:N4ZIA8X00
对码 Binding
1. 将发射机进入对码状态;(发射机进入对码状态的方式可能不同,请根据发射机的使用说明书进行操作)
2. 接收机接通电源即进入对码状态;
接收机接通电源,进入对码状态;
接收机指示灯快闪表示进入对码状态;
3. 当接收机指示灯变为常亮时,表示对码成功,即可与接收机正常通信。
4. 检查发射机、接收机、模型是否正常工作。如需重新对码,请重复以上步骤重新对码。
http://www.flysky-cn.com
Copyright ©2020Flysky Technology co., ltd
FS-iA8X
用于连接接收机与模型的各个部件。
PPM 信号接口:输出标准的 PPM 信号。
i-BUS/S.BUS 信号接口:用于输出 i-BUS/S.BUS 信号。
VCC:电源电压为 4.0~8.4V。
GND:连接地线。
注:接收机将 RSSI 数据转换成 CH14 通道值通过 i-BUS/S.BUS 输出给
PPM
飞控,信号强度为 0 时对应通道值为 1000,信号强度为 100 时对应通
i-BUS
道值为 2000,线性对应相关。
S.BUS
VCC
These ports connect the receiver to various models, component's and
flight controllers.
GND
PPM signal port: Outputs standard PPM signal.
i-BUS/S.BUS signal port: Output i-BUS /S.BUS signal.
VCC: Power supply voltage from 4.0 – 8.4V.
GND: Connect to ground wire.
Note: The receiver uses CH14 for output of RSSI data to the
onboard flight controller via i-BUS/S.BUS. The receiver signal
strength data from the onboard flight controller will be displayed
as values between 0 and 100 (100 being max signal strength) and
the corresponding values displayed on CH14 on the transmitter
will be 1000 and 2000 (2000 being max signal strength).
The FS-iA8X is a single antenna bidirectional receiver using
the AFHDS 2A (Second Generation Automatic Frequency
Hopping Digital System) protocol. It's compact, easy to install
and can output using a standard PPM or i-BUS /S.BUS signal.
Product Name: iA8X
Model Type: Multi Rotor
RF: 2.4GHz
Protocol: AFHDS 2A
Antenna: Single Antenna
Data Output: PPM/i-BUS/S.BUS
Input Power: 4.0-8.4V
Temperature Range: -15℃—+60℃
Humidity Limit: 20%-95%
Online Update: No
Dimensions: 15*13*3mm
Weight: <2g
接收机 Receiver
Need help?
Do you have a question about the FS-iA8X and is the answer not in the manual?
Questions and answers