Table of Contents
Advertisement
DISPLAY (in PC Mode)
Using the Display menu, you can adjust the display settings of your projectors. The
Display menu provides the following options:
SPECT
ATIO
—Allows you to set the aspect ratio.
A
R
•
4:3 - The input source scales to fit the screen.
•
Original - The input source scales to fit the screen while keeping the aspect ratio
of the input source.
•
Wide - The input source scales to fit the width of the screen.
Use Wide or 4:3 if you are using one of the following:
- Computer resolution greater than SVGA
- Component cable (720p/1080i/1080p)
IGITAL
OOM
D
Z
—Press
screen and press
OOM
AVIGATION
Z
N
—Press
ORIZONTAL
OSITION
H
P
image to the left.
ERTICAL
OSITION
V
P
—Press
REQUENCY
—Allows you to change the display data clock frequency to match the
F
frequency of your computer graphics card. If you see a vertical flickering wave, use
Frequency control to minimize the bars. This is a coarse adjustment.
RACKING
T
—Synchronize the phase of the display signal with the graphic card. If you
experience an unstable or flickering image, use Tracking to correct it. This is a fine
adjustment.
DISPLAY (in Video Mode)
Using the Display menu, you can adjust the display settings of your projectors. The
to digitally magnify an image up to 4 times on the projection
to reduce the zoomed image.
to move the image to the right and
—Press
to move the image down and
to navigate projection screen.
Using Your Projector
to move the
to move the image up.
19
Advertisement
Table of Contents
