Table of Contents
Advertisement
741 eng.book Page 25 Tuesday, April 27, 1999 11:35 AM
SPECI A L FEA T U RES ON Y OU R V CR
LOW POWER FEA T U RE
To meet new power regulations your VCR can be placed in LOW POWER mode. In LOW
POWER mode the VCR power consumption is reduced to below 2 Watt.
LOW POWER M OD E
1.
2.
The VCR power consumption will now be below 2 Watt.
D I SEN GA GI N G LOW POWER M OD E
Either
Or
NOTES:
CH I LD LOCK
You can lock your VCR with this feature. It will work even when the VCR is in standby,
preventing children from operating the VCR.
T O EN GA GE CH I LD LOCK
Press and hold
has been activated.
Regardless of what other operating buttons are touched, the VCR will continue to operate in
its present mode. If CHILD LOCK is activated during playback, once the tape reaches its end,
the VCR will automatically rewind the tape, eject it, and turn the power off.
T O D I SEN GA GE CH I LD LOCK
Press and hold
NOTES:
Downloaded from:
http://www.usersmanualguide.com/
Press
ST A N D BY
(
Press
ST A N D BY
(
display will appear blank.
Press
ST A N D BY
ST OP
Press
(
•
With poor signal conditions an increase in noise may be observed on the screen in LOW
POWER mode.
•
When entering STANDBY, noise may be observed.
•
If a signal is input from an AV source, the VCR may not go into true LOW POWER mode.
•
When disengaging low power mode from the VCR press the Standby button.
on the remote control for about 2 seconds.
flashes and then
for about 2 seconds.
starts flashing and then disappears. CHILD LOCK is disengaged.
•
If you attempt to change modes by pressing another button while CHILD LOCK is on,
the
indicator will flash on the VCR display.
•
If power is interrupted for more than 1 hour (due to power failure etc), CHILD LOCK may
disengage.
) to place the VCR in STANDBY mode.
) again to place the VCR in LOW POWER mode. The VCR digital
(
) to return the VCR to STANDBY mode.
) to use the VCR.
remains lit on the VCR display confirming that CHILD LOCK
GB-25
Advertisement
Table of Contents
