Kenwood KRC-265RG Instruction Manual page 27

Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the tw o
locks on the low er level.
Low er the frame and pull it forw ard as show n in the figure.
Accessory 2
Removal tool
2
When the low er level is removed, remove the upper tw o
locations.
The frame can be removed from the top side in the same manner.
Catch
Lock
— 27 — — 27 —
Removing the Unit
1
Refer to the section " Removing the hard rubber frame" and then
remove the hard rubber frame.
Remove the screw (M 4 × 8) on the back panel.
2
3
Insert the tw o removal tools deeply into the slots on each side,
as show n.
Screw (M 4X8)
(commercially
available)
4
Low er the removal tool
tow ard the bottom, and pull
out the unit halfw ay w hile
pressing tow ards the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5
Pull the unit all the w ay out
w ith your hands, being
careful not to drop it.
Accessory 2
Removal tool