Klarstein Azuria Manual page 44

EN
44
Important notes
• The salt container must only be refilled when the salt warning light (
control panel comes on. Depending on how well the salt dissolves, the salt warning
light may still be on even though the salt container is filled.
• If there is no salt warning light in the control panel (for some Models), you can
estimate when to fill the salt into the softener by the cycles that the dishwasher has
run. If salt has spilled, run a soak or quick program to remove it.
Adjusting the salt consumption
Close the door, within 60 seconds after power on, press Start/Pause button and hold
for 5 seconds, the machine will enter setting mode.
Press the Start/pause button to select the proper set according to your local environment,
the sets will change in the following sequence: H1 > H2 > H3 > H4 > H5 > H6.
There are 6 levels of salt consumption in all. It is recommended to select the level
according to below table:
Water hardness level
°dH mmol/l
1
0-5 0-0.9
6-1 1 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.1
35-45 6.2-8.0
¹ German degree of measurement for the water hardness
² International unit for water hardness
Factory setting
*
Note: Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
Setting on the
water softener
2
1
2
3
4
*
5
6
) in the
Digital Display stalls
H1
H2
H3
H4
H5
H6