Advertisement
6.3.6.
Pour 15grms of oil into the bore (fig.6). Insert larger seal (fig.7.6) as shown, with the widest part of the seal facing downwards into
the bore. Push down into main cylinder as far as 'X' (fig.7) followed by piston (fig.7.4) and spring (fig.7.3).
6.3.7.
Refit (do not over tighten) ram cover (fig.7.2) and replace T-handle (fig.7.5).
ˆ
Warning! the correct orientation of pistons and seals in the ram is critical.
6.3.8.
screw t-handle into ram until it contacts small piston and then turn a further two or three times.
6.3.9.
Remove T-handle and firmly bounce the ram piston (fig.8) on a hard, but non-damaging, surface 6 to 10 times to consolidate the oil.
replace the t-handle, wipe clean and the ram is ready for use.
A ram repair kit is available, quote part number: PS9821.11. Oil needs to be obtained as well. A single 15grm refill of oil may be
obtained by quoting Part no.Ps982/oil.
environMent protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
Ps9821 issue:3 (H,4,f) - 14/03/18
Advertisement
