Assembly - Husky HOLT62XDB11 Use And Care Manual

Assembly

1.
While unpacking the unit, you can leave the workbench wood top (A)
inside the original packaging to prevent the top from being
scratched during assembly.
2. Determine the front and back of the top before starting. The front of
the wood top (A) has the Husky badge on the edge.
3. Attach right leg (B) to the wood top (A) as shown using four M6x 15L
screws (AA). Be sure that the rotating mechanism faces the inside
of work table.
Note: Do not overtighten the screws into the wood top to avoid
damaging the wood top.
B
Front
Attach the rotating rod (G) to the rotating mechanism in leg (B).
4.
B
A
Front
Note: Do not turn the rotating rod yet to ensure that the leg remains
at its lowest level.
□
AA
A
G
5. Attach the left leg (E) to the wood top (A) using four M6x15L screws
(AA). Finger tighten only. Be sure that the rotating rod (G) clicks into
the leg (E).
A
Front
Attach the top rail (F) to the wood top (A), leg (B), and leg (E) using
6.
fourteen M6x15L screws (AA). Do not overtighten the screws.
B
F
7a. Attach the support rail (H) to the bottom of leg (B) and leg (E) using
four M8x15L bolts (BB) and four M8 washers (CC). Finger tighten only.
The support rail can attach in the middle or rear of leg. Attach it at
your desired position.
B
6
6
G
E
AA
BB
H
AA
E
CC
E