XO Appliance XOU15WGO Series Manual page 11

let's face it
BEFORE BEGINNING - REST THE UNIT ON ITS BACK, WITH THE DOOR FACING UP
1. Remove the two screws that hold the toe kick in place.
Remove the toe kick and set aside.
2. Remove the three screws holding the lower hinge in place.
Remove the hinge and set aside.
3. Pull the door down away from the upper hinge to remove it
and lay it flat face down on a pad to prevent scratches.
4. Starting at one corner, gently pull the rubber door gasket out
of the channel. Lay it aside, flat. You will reinstall it shortly.
In the channel are 10 screw holes.
5. Attach your door handle to the frame, countersinking the screw
heads so the frame lays flat against the door..
6. Align the frame to the door. If the frame is wider than the door,
set the frame flush with the hinge side of the door, let the other side
overhang the door and clamp securely.
7 Using the (10) ST4-30 self-tapping screws supplied securely fasten
the frame to the door. Do not over tighten as screws may strip out.
WARNING: Screws are sized for 3/4" panel,
DO NOT USE these screws for thinner panels.
11