KEUCO Edition 90 19097 Instructions For Use Manual page 4

US
Read all instructions before using or installing this product.
Operation
Button functions
Button Function
Light on/off
• Pressing the button switches the mirror on
with the selected settings. The white LED
goes off .
• Pressing the button again switches the mirror
off . The white LED lights up.
• The white LED can be deactivated.
– Switch on the mirror.
– Press and hold the button for 10 seconds.
- The lighting goes off .
- A short light impulse indicates that the
white LED was deactivated.
To switch the white LED back on, repeat the
described procedure.
Front lighting
• The front lighting is switched on by pressing
the button when mirror is switched on.
• Pressing the button again switches the light
off .
Washbasin lighting
• The washbasin lighting is switched on by
pressing the button when mirror is switched
on.
• Pressing the button again switches the light
off .
When both lightings are switched off , the mirror
also switches off .
Dimming the front and washbasin lighting
• Press the button when the mirror is switched
on and hold until the desired brightness or
the end value has been reached.
The setting is stored and reproduced when
switched on again (only for connection type I,
see fi gure 1 on page 17).
Setting the light colour cooler
• Press and hold daylight white button and the
light colour fades to cool white.
• Release when the desired light colour has
been reached.
The setting is stored and reproduced when
switched on again.
Adjusting light colour - daylight white (cool
white)
• Press button and the colour temperature sets
to 6500 Kelvin.
4
Button Function
Setting the light colour warmer
• Press and hold warm white button and the
light colour fades to warm white.
• Release when the desired light colour has
been reached.
The setting is stored and reproduced when
switched on again.
Adjusting light colour - warm white
• Press button and the colour temperature sets
to 2700 Kelvin.
Replacement parts with order numbers, see page 15.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions
and Warranty Card.
Disposal instructions
This category of device does not belong in
the domestic waste, but must be disposed of
separately in accordance with the relevant
local national regulations.