Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CorroVenta K5 HP PX
Summary of Contents for CorroVenta K5 HP PX
- Page 1 CONDENSING DRYER K5 HP PX USER MANUAL...
-
Page 2: Table Of Contents
Maintenance and service ......................14 Inspection and cleaning of process air filters, water filters and cleaning of drip trays and bucket . 15 Accessories and consumables ......................16 Fault tracing ............................16 Technical data ............................17 © Corroventa Ltd. 2020.04 1 (17) -
Page 3: Area Of Use
K5 HP PX has a built-in pump to allow continuous operation and a bucket for occasions when it is difficult to get rid of condensation water. -
Page 4: Manufacture Directive
Manufacture directive Condensing drier K5 HP PX is tested according to applicable directives and standards by Intertek. The dryer is CE labelled. Disclaimer Incorrect installation and/or incorrect use can cause damage to property as well as injury. • The manufacturer assumes no liability for property damage or injury incurred as a result of •... -
Page 5: Safety Information
20. The dryer must not be used with accessories other than those described in this manual or approved by Corroventa Avfuktning AB. 21. The dryer must be placed at a distance of at least half (0.5) a metre from walls and ceilings to ensure that air can circulate. -
Page 6: Relative Humidity And Its Impact On Materials
At 100% RH the air is saturated, and the moisture falls in the form of small water droplets. Steel corrodes at 60% RH and at 70% RH there is a risk of mould. A rule of thumb is that 50% RH is a good climate for most materials. © Corroventa Ltd. 2020.04 5 (17) - Page 7 As the graph above shows, condensing dehumidifiers are used in hot and humid spaces if room drying is required. © Corroventa Ltd. 2020.04 6 (17)
-
Page 8: This Is How The Dryer Works
The dry and hot air is then blown into the premises again. For optimal operation, machine defrosting is demand controlled and is only activated when the temperature and humidity conditions are such that frost forms on the cooling coil. © Corroventa Ltd. 2020.04 7 (17) -
Page 9: Overview, Controls And Connections
Overview, controls and connections The images below show Corroventa K5 HP PX with its external parts and controls. Folding handle/ Process air filter Carry handle Dry air connectors for hose connection Durable feet that allow stackability and prevent damage to Bucket surfaces. -
Page 10: Alarm/Indicator Lamp
Internal fault. Disconnect the machine from power for a few minutes and restart again. If the alarm remains, contact a service technician. YELLOW The lamp indicates that the additional heater function has been activated. © Corroventa Ltd. 2020.04 9 (17) -
Page 11: Electrical Connection
Electrical connection The machine is connected to the earthed 230V/50Hz socket. K5 HP PX can be connected to a 10A, max 16A, fuse. Electronic control delays the start approx. 2 minutes. Starting and operating • Operating range humidity: 30-100% RH •... -
Page 12: Transportation
The machine restarts automatically when the evaporator is clear of ice. 7. K5 HP PX is equipped with an additional heater that increases the dry air temperature and thus improves the drying effect further. The additional heater's operating range is between 20-26 °C. -
Page 13: Storage
Storage K5 HP PX can be stored stacked on top of each other as shown below, thus saving floor space. The machine must always be stored upright, frost-free and in a ventilated area without sources that may cause sparking or near flammable substances. -
Page 14: Bucket
9 litres. The compressor stops when the bucket is full and the red lamp illuminates. In order for the machine to resume drying, the bucket must be emptied Depress the catch and pull the bucket straight out. © Corroventa Ltd. 2020.04 13 (17) -
Page 15: Maintenance And Service
Replace the process air filter frequently, preferably before each new job it is installed for, and clean the dryer regularly, as dust and dirt reduce capacity and may cause overheating and fire. © Corroventa Ltd. 2020.04 14 (17) -
Page 16: Inspection And Cleaning Of Process Air Filters, Water Filters And Cleaning Of Drip Trays And Bucket
Replacing/cleaning condensation water filter Remove, carefully pull out the condensation water filter. Clean or replace as necessary. Check and clean the drip tray. Reinstall the water filter carefully. © Corroventa Ltd. 2020.04 15 (17) -
Page 17: Accessories And Consumables
Accessories and consumables The following parts are available as accessories and consumables for K5 HP PX: Part number Designation 01100 Hygrostat HS1-5 (5m cable) 1003146 Condensation water filter 1002827 Process air filter Fault tracing Fault symptom Probable cause Actions The capacity of the dryer Low ambient temperature or Check relative air humidity. -
Page 18: Technical Data
Technical data K5 HP PX Operating range, RH, % 30-100% Operating temperature range, °C +9 to +38 Rated output, W 500 (incl. additional heater: 1700) Additional heater W 1200 (full temperature control) Actual output at 20°C,60% RH W Dehumidification, max., litres per 24 hours Dehumidification at 30°C, 80% RH, litres per 24 hours...
Need help?
Do you have a question about the K5 HP PX and is the answer not in the manual?
Questions and answers