Table of Contents
Advertisement
Installation Procedure
Setting an indoor unit installation option (suitable for the condition of each installation location)
• The indoor unit installation option are set to 020000-100000-200000-300000 by default.
• Set the indoor unit option by wireless remote controller. When entering Address option, connect remote controller
receiver.
Installation options
SEG1
0
SEG7
1
Using of drain pump
SEG13
2
SEG19
3
with remote control
• Even if you set the Use of drain pump (SEG8) option to 0, it is automatically set to 2 (the drain pump is used with 3
minute delay).
• If you set the Maximum filter usage time (SEG18) option to a value other than 2 and 6, it is automatically set to 2
(1000 hours).
• If you set an option to a value that is out of range specified above, the option is automatically set to 0 by default.
• The external output of SEG15 is generated via MIM-B14 connection. (Refer to the manual of MIM-B14.)
• If you set the Individual control with remote control (SEG20) option to a value other than 0 to 4, it is automatically set
to 0 (Indoor 1).
26
English
SEG2
SEG3
2
Reserved
SEG8
SEG9
Reserved
SEG14
SEG15
Use of external
Setting the output of
control
external control
SEG20
SEG21
Individual control
Heating setting
compensation offset
SEG4
SEG5
Use of external
Use of central control
temperature sensor
SEG10
SEG11
Reserved
Reserved
SEG16
SEG17
S-Plasma ion
Buzzer Control
SEG22
SEG23
Dew removal
Motion detection
operation in wind free
sensor
mode
SEG6
Compensation of the fan RPM
SEG12
Remote control
SEG18
Hours of filter usage
SEG24
Reserved
Advertisement
Table of Contents
