icon flashes
Is the handset registered correctly to the base, see page 29.
•
Check that the mains power is correctly connected.
•
Check that the handset is within range of the base.
•
The batteries are low, place the handset on the base/charger to recharge.
•
You hear the busy tone when you press
Make sure the handset is in range of the base.
•
Another handset registered to your BT Graphite 2100 base may be on the line.
•
No Caller Display number/name displayed
Have you subscribed to a Caller Display service from your network provider, see page 23.
•
The caller may have withheld their number.
•
An exact name/number match was not found in your directory. Check that you have stored the
•
full STD dialling code.
Cannot register a handset to a base
You can register a total of up to 5 handsets to your BT Graphite 2100 base. Check that you have
•
not exceeded the limit.
Check that you have entered the correct PIN number (default PIN 0000).
•
Check that you are at least one metre away from other electrical equipment to avoid interference
•
when registering.
Base unit does not ring, but the lights are on
Have you connected the telephone line correctly?
•
Is the base ringer set to off?
•
You may have a faulty line or socket. Try using another socket or line. Call BT on 151 if you still
•
experience problems.
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp
.
32