Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
fan with light kit?"
Ceiling Bracket
Downrod
2 of 3
Assembly Screw
bag
5
Lift the lower switch housing until its screw
holes are aligned with the screw holes in
the upper switch housing. Install the three
switch housing screws, found in the
hardware bag. Tighten all three screws.
Installing the Pull Chain
Note:
and click "How do I install my
Fan style may vary.
Hanging Fan
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
3 of 3
Light Kit Screw
bag
Feed the pull chains from the fan
switch down through the hole in the
upper switch housing as shown.
Attach the pull chain pendants to
the fan pull chains.
Wiring
3
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
The fan pull chain controls
the speed: from high to off.
Canopy
Blades
1886
Assembly
Screw
1 of 3
bag
ON
8
Control
Advertisement
Table of Contents
