Table of Contents
Advertisement
Contact with moving scissor arms can cause
personal injury.
• Stand clear of scissor arms while platform
is moving.
• Make sure area is clear of bystanders before
lowering platform.
• Never work under raised platform without
lift safety blocks installed.
• Always remove key from lift control box
when platform is not in use.
Figure 24
1. Emergency lowering valve knob
3. To stop lift and return to normal operation, push
button in, rotate 180 degrees clockwise and release.
Falling or jumping from raised platform will
cause personal injury.
• Secure both handrail snap chains across
opening before raising platform.
• Never pull on objects while reaching from
raised platform.
• Never reach over handrails unless both feet
are on platform deck.
• Never step above level of platform deck or
use ladders, step risers or platform rails to
extend working height of platform.
• If you must exit raised platform, slowly and
carefully climb down outside of scissor arm
frame.
Operating Tips
The electrical system, battery and hydraulic lift cylinder
are not designed for continuous use. Allow some
time, approximately 1-1/2 to 2 minutes, between lift
operations to maintain operating temperatures.
Frequent use without the engine running or idling,
between lift use, may discharge the battery. If engine
operation is not possible to keep battery charged, it
may be necessary to supplement operation with an over
night battery charger.
Check the specific gravity of the fluid in the battery to
assure it is fully charged. Refer to Battery Care section.
18
Advertisement
Table of Contents
