Monster SMART ILLUMINESSENCE Multi-Color LED Light Bar+ Quick Start Manual page 4

STEP 3
Make sure your phone or tablet is successfully connected to the
2.4GHz Wi-Fi network that your Light Bar+ will be placed on.
Open the
account by following the on-screen instructions.
STEP 4
It is recommended to first pair your Light Bar+ in a location close to
your router BEFORE installation.
Connect the USB plug to any powered 5V 2A USB power source
(not included), the Light Bar+ will begin blinking when it has
entered pairing mode and is ready to pair.
Pairing Modes:
EZ MODE - RAPIDLY BLINKING LED (default)
EZ Mode is the default mode for quick and easy pairing setup.
AP MODE - SLOWLY BLINKING LED
Access Point Mode is a secondary setup that can help connect to
mixed networks.
Press and hold the controller button for 5-6 seconds to enter
pairing mode or change between pairing modes.
NOTE: At any time after 10 seconds of pairing mode you can
disconnect the power for 10 seconds and then reconnect it to
cancel pairing and operate the product without Wi-Fi. Advanced
features will not be available.
Follow the on-screen step by step instructions.
app and create an
3