Summary of Contents for Norfolk Greenhouses BCPOSW1915+G
Page 1
Porch 1.9m BCPOSW1915+G Assembly Instructions IMPORTANT Please read these instructions thoroughly before starting assembly. Check all parts are present before assembly, call 020 3011 2040 for replacement parts. These instructions should be kept in a safe place for future use.
Page 2
Porch Introduction Thank you for your purchase of our Carport, we hope you enjoy. Please read through these instructions and familiarise yourself with the construction process before you begin. We operate a programme of continuous product improvement and we reserve the right to change the specification without prior notice, the latest model is supplied.
Page 6
Parts List Porch Roof & Windows TW150 (1395mm x 620mm) TW151 (1030mm x 275mm) SAN34 (1145mm x 225mm) SAN33 (1145mm x 665mm) SAN35 (990mm x 650mm) SAN36 (1145mm x 584mm)
Page 12
Side Wall Assembly Porch Step 5 - Insert 5x IG1 into each side of HS1 and US24 Step 6 - Slide SAN33 and 2x SAN34 into IG channels as shown Remove blue/ green film from SAN panels before inserting into frame.
Page 14
Side Wall Assembly Porch Step9 - Fasten RLD4A in position using fixings as shown Do not over tighten TUS5X80 screws. Step 10 - Repeat Steps 1-9 with Cladding Boards reversed to create Right Side Wall Left Side Right Side Wall Wall...
Page 16
Front Wall Assembly Porch Step 13 - Slide 4x CD6W and 2x CD9W into IC channels as shown Step 14 - Fix RLD9 and 2x RLD3 on top of Cladding Using pliers, compress top edge of Cladding Board to help it fit inside the channel of the RLD.
Page 20
Roof Assembly Porch Step 20 - Fix AN3 through holes provided flush with the rear of the building. Add 2x HBD brackets to the inside of each RLD4A as shown. Step 21 - Fix RL12 in position between HBD brackets with groove facing up...
Page 22
Roof Assembly Porch Step 24 - Using TW150 as a guide, align SJB1 and fix to RL11 and RL12 Step 25 - Remove TW150, place 2x FS1A and TS1 in each roof bay as shown...
Page 30
Door Assembly Porch Step 39 - Fix door in opening with the Hinges on the inside Allow below door Step 40 - Attach support rail XL3 to underside of RL12...
Page 32
Fix & Seal Porch Step 43 - Drill holes in AN3 and fix to wall (fixings not provided) Use appropriate fixings for application Step 44 - Locate AB1 brackets where necessary to fix building to floor and wall Offer AB1 brackets between building and wall/floor in desired location.
Page 34
Fix & Seal Porch Step 47 - Apply Mastic between AN3 and Wall, and between AN3 and TW150 Step 48 - Apply Mastic around all windows and cladding...