Starting The Engine; Using The Self-Propel Drive; Shutting Off The Engine - Toro Super Recycler 21381 Operator's Manual

Starting the Engine

1. Pull the blade-control bar to the handle and hold it (A of
2. Pull the recoil-start handle (B of
to return to the rope guide on the handle slowly.
Note:
If the machine does not start after several attempts, contact an Authorized Service Dealer.

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (Figure 15).
Figure 15
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
Figure 14) lightly until you feel resistance, then pull it sharply, and allow it
Figure 14

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
g233423
13
Figure 14).
When you release the blade-control
g231913