Base Installation Instructions; Power Supply - Definitive Technology Mythos Mythos STS Owner's Manual

Safety Precautions Specific to Mythos ST
The cautionary marking label is located on the bottom of the speaker,
visible through an opening in the granite base.

Power Supply

1. The fuse and power disconnect device are located on the bottom of the
speaker, accessible through a hole in the granite base.
2. The disconnect device is the power cord, detachable at either the speaker
or the wall.
3. The power cord must be disconnected from the speaker before servicing.
Unpacking Your Mythos STs
Please Inspect For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or
concealed damage most likely occurred in handling after it left our plant and
should be reported at once to your Definitive dealer or the delivery company that
delivered your loudspeaker. Please unpack your system carefully. Save all cartons
and packing materials in case you move or need to ship your system. Record the
serial number found on the back of the Mythos ST in the appropriate place on your
warranty card, answer all questions and send it in.

Base Installation Instructions

Tools required: 4mm (or
Parts required: Polished Granite Base, Cable Clip for AC Cord,
four allen head bolts, eights plastic washers
Instructions:
1. Carefully lay the Mythos ST on its side. Lift the base of the speaker about six
inches and support it with a soft padded object, such as a pillow. Do NOT
support the speaker with a hard object, as you might dent or scratch the
aluminum finish.
2. Place one plastic washer on each bolt.
3. Insert the bolts into the granite base from the same side that the black feet are
attached to.
4. Place another plastic washer on each bolt so the washer is against the granite.
5. Finger tighten all four bolts into the threaded holes on the bottom of the
Mythos. If this has been done correctly, washers will be between the metal
surface of the Mythos ST, the granite, and the heads of the bolts.
6. GENTLY tighten each bolt with the allen head wrench. Do NOT overtighten
or you may crack the granite.
5
/ ") Allen Wrench (also called Hex Key driver)
32
3