LG LT-H282PLE0 Installation Manual page 23

Form the pipings
1
Wrap the connecting portion of indoor unit
with the Insulation material and secure it
with two Plastic Bands. (for the right pip-
ings)
• If you want to connect an additional drain
hose, the end of the drain-outlet should
keep distance from the ground. (Do not dip
it into water, and fix it on the wall to avoid
swinging in the wind.)
In case of the Outdoor unit being
installed below position of the Indoor
unit.
2
Tape the Pipings, drain hose and
Connecting Cable from bottom to top.
3
Form the pipings gathered by taping along
the exterior wall and fix it onto the wall by
saddle or equivalent.
Seal a small opening
around the pipings
with gum type sealant.
Trap is required to prevent water from entering
into electrical parts.
In case of the Outdoor Unit being
installed above position of the Indoor
Unit.
4
Tape the Pipings and Connecting cable
from bottom to top.
5
Form the pipings gathered by taping along
the exterior wall, and make the trap pre-
vent water from entering into the room.
6
Fix the pipings onto the wall by saddle or
equivalent
Drain hose
Taping
Pipings
Connecting
cable
Power supply
cord
INSTALLATION
23
Seal a small opening
around the pipings
with gum type sealant.
Trap