molex 63885-1061 Manual

Wire Guide Funnel – Mylar Tape Carrier

FEATURES

Œ
Directly mounts to face of 63885-1000 applicator.
Œ
Provides additional wire guidance to prevent wire strands from folding back outside the terminal barrel.
Œ
Adjustable funnel height to match various terminal barrel heights.
Œ
Intended for use in automatic wire processors with split-cycle presses.

SCOPE

Products: Terminals crimped in the applicator listed below, use a 4.7 mm (0.169 in.) nominal wire insulation diameter. Wires with
smaller insulation diameter may not be effectively guided in the funnel.
Applicators:
63885-1000

Product List

From the applicators listed above, refer to the product list on the applicator specification sheet available at www.molex.com.

WIRE GUIDE FUNNEL ASSEMBLY

The wire guide funnel consists of a slide assembly and a (wire-specific) funnel
assembly. Funnels must be installed on the slide before mounting the unit to
the applicator.
1. Place the compression spring in the pocket of each funnel half and
squeeze the halves together. See Figure 1.
2. While holding the halves together, put the headed pins through the pivot
holes and into the funnel slide. Make sure the flats on the pins face
outward.
3. Using a 1.5mm hex wrench, tighten each setscrew holding the pins in
place. See Figure 2. The funnel halves should open freely under spring
pressure.
Doc No. 63885-1061 Release Date: 03-02-06
Revision: A Revision Date: 03-02-06
Mini-Mac Applicator Accessory
Application Tooling Specification
Wire Guide Funnel – Mylar Tape Carrier
Order No. 63885-1061
UNCONTROLLED COPY
SPRING POCKET
COMPRESSION SPRING
SQUEEZE TOGETHER
Figure 1
Page 1 of 5