Time Out Period - DAVIS WeatherLink Addendum

For alarm output

Hide thumbs Also See for WeatherLink:

Table of Contents

Time Out Period

The Alarm Output data logger will always hold an attached device in the

appropriate state (On or Off) as dictated by the alarm settings. However, the

Alarm Output data logger utilizes a time-out period for ceasing checking the

alarm conditions whenever software attempts to communicate to the logger.

The default and minimum setting is 5 seconds. Once the time out period

ends, the data logger will again check the alarm conditions to determine

whether to leave an output open or closed. You may adjust this value if you

want the alarm checking functions to resume later after communicating to the

logger using WeatherLink or the Streaming Data Utility.

Press OK to configure this setting in the dialog box. Press Cancel to exit the

dialog box and preserve the original settings.

Note: Once communications to WeatherLink are initiated and successful, the

streaming data logger will be unable to communicate with the Streaming

Data Utility until the Time Out Period expires. If you need to communicate to

the logger with both the Streaming Data Utility and WeatherLink, you should

communicate using the Streaming Data Utility first.

Table of Contents