Universal Furniture 192-655 Instruction Sheet

192/193-655
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Table Top
C Pedestal
E Leaf bag
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Rest the table top (A) with its upright down on a flat smooth surface to avoid damage or being
scratched, Attach the center rail (B) to the pedestal (C) with phillip head bolt(1), flat washer(2)
and lock washer(3) by wrench(4).
Step 3: Attach the assembled pedestal to the table top (A) with the bolts, lock washers, flat washers
from step 2. Tighten all the bolts by wrench (4).
Step 4: Turn the table upright. Unlock the table top (A), take off the leaf (D) as shown when leaf is not
used. Then lock the table top. Note: Store the leaf (D) into the leaf bag (E) when it is not in
use.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
1 pc B
2pcs D
1bag F
: (Please follow the sketches below.)
GOOD, AFFORDABLE, SMART DESIGN.
Family-Style Table
Description
Center Rail
Leaf
Hardware pack
Qty.
2pcs
1pc
1bag