Advertisement
Two 1/2" U-Bolts (for
n.
anemometer arm)
Two 1/2" Saddles
o.
Two 1-1/2" U-Bolts (for
p.
pipe with outside diameter
between 1" and 1-1/4"
(25 mm and 31 mm)
Two 2-1/4" U-Bolts (for
q.
pipe with outside diameter
between 1-1/2" and 2-3/8"
(38 mm and 60 mm)
Two 2-1/4" Saddles
r.
Three #8-32 x 3/4"
s.
(19 mm) Screws
Two #8-32 x 2 -1/2"
t.
(64 mm) Screws
T
M
OOLS AND
ATERIALS
In addition to the components listed above, you will need some of the follow-
ing tools and materials. Please be sure you have everything you need before
beginning the installation.
Medium Phillips Screwdriver
Wrench or Pliers
11/32" (9 mm) Nut Driver or Socket Wrench
If mounting the anemometer on the same side as the Radiation Shield.
A
SSEMBLING THE
The assembly of the sensor arm involves attaching the mounting bracket and
then attaching all desired sensors. Instructions for attaching sensors (other than
the anemometer) to the Sensor Mounting Arm are contained in the manual for
that sensor or for the accessory which allows that sensor to be attached (such as
the Radiation Shield or the Rain Collector Shelf). The Sensor Mounting Arm
includes provisions for attaching the following sensors:
Anemometer
External Temperature Sensor, External Temperature/Humidity Sensor, or Stainless
Steel Temperature Probe (with Radiation Shield or Solar-Fan-Aspirated Radiation
Shield)
Rain Collector (with Rain Collector Shelf)
UV Sensor (with or without Tilting Mechanism)
Solar Radiation Sensor (with or without Tilting Mechanism)
Page 2
N
EEDED
S
M
ENSOR
OUNTING
A
RM
Sensor Mounting Arm
Advertisement
