Advertisement
9 DO NOT allow children or untrained persons to operate the glue gun.
8
9
9 9 DO NOT allow the glue to contact skin.
8
9
9 9 DO NOT inhale any vapour given off by the glue.
8
9
9 DO NOT carry the glue gun with your finger on the power switch, or carry by the power cable.
8
9
9 DO NOT use the glue gun where there are flammable liquids, solids or gases such as paint solvents, etc.
8
9
9 9 DO NOT leave the glue gun unattended whilst it is switched on.
8
9
9 9
9
When not in use switch the glue gun off, remove plug from the power supply, store safely in the case
2. INTRODUCTION
High quality kit for the removal of small dents without the need for respraying/refinishing the painted surface. Pulling tool for use on flat surface
includes large rubber feet to avoid damage to the paint work and rotates 360 degrees to allow use in more restricted areas. Slide hammer is
included for use on bigger dents and dents on corners or curves. 12 Plastic tabs of varying sizes and shapes are included to cover a wide range
of dents. Kit includes plastic scraper and glue removal spray to avoid damage to surface.
3. CONTENTS
4. OPERATION
4.1.
PREPARATION
4.1.1.
Connect the glue gun to the electric supply.
4.1.2.
Heat the glue to operating temperature by inserting a glue stick into the gun.
4.1.3.
Apply hot glue into the dent.
4.1.4.
Whilst the glue is still hot, press the appropriate dent repair tab into the glue. Wait for the glue to
set.
4.2.
DENT PULLING (Plastic Pulling Tool)
4.2.1.
Place the pulling tool over the dent.
4.2.2.
Connect the boss of the dent repair tab into the slotted opening at the end of the pulling shaft
(fig.1).
4.2.3.
Take up the slack by means of the knurled wheel above the handle.
4.2.4.
Close the handles of the puller gently, pulling the dent out.
4.3.
DENT PULLING (Slide Hammer)
4.3.1.
A slide hammer is included for use with larger dents or dents in locations which preclude the
use of the pulling tool.
4.3.2.
Follow steps 4.1.1 to 4.1.4.
4.3.3.
Connect the slide hammer to the dent repair tab as in fig.2.
4.3.4.
Proceed to pull the dent out by striking the slide hammer weight against the stop.
4.4.
TAB REMOVAL
4.4.1.
Using the scraper, ease the glue away from the painted surface. The glue release spray will help
with the release.
4.4.2.
The dent repair tabs can be reused.
© Jack Sealey Limited
No
1
2
3
4
5
6
7
8
Original Language Version
.
Part no
Description
RE105.BMC
Blow moulded case
RE105.GG
Glue gun
RE105.GRS
Glue removal spray 50cc
RE105.PC
Plastic chisel
RE105.PPT
Plastic pulling tool
RE105.SH
T-bar slide hammer
RE105/1
PDR dent repair tabs (pack of 12)
RE105/2
PDR glue stick (pack of 25)
fig.1
RE105 Issue 2 12/02/19
fig.2
Advertisement
