Operation; Specifications; Warranty - Napa Carlyle Tools 6-754A Instruction Manual

OPERATION

Always turn off the air supply, drain
hose of air pressure and detach tool
from air supply before installing,
removing or adjusting any part or
accessory on this tool, or before per-
forming any maintenance on this tool.
Bonded abrasive mounted
grinding wheels, rotary files and carbide
burrs can be mounted providing their
speed rating exceeds the speed of
the Die Grinder. The shank size of the
mounted accessory must match the
collet size fitted in the Die Grinder.
Insert the shank of the mounted point
as far as possible into the collet and
tighten the nut using the supplied
wrenches. Minimum shank gripping
length must be 10mm.
After mounting a new point, start the
Die Grinder under bench and run for a
few seconds. If the Die Grinder starts
to vibrate when first fitting a mounted
point or during operation, immediately
remove from service. If Die Grinder
is dropped, replace bonded abrasive
mounted point grinding wheel, rotary
file or carbide burr.

WARRANTY

Important: DO NOT RETURN DEFECTIVE PRODUCT OUTSIDE OF ORIGINAL ONE (1) YEAR WARRANTY PERIOD TO
PLACE OF PURCHASE.
WARRANTY POLICY:
from the date of original purchase. We will replace, at our option, any part which proves to be defective in material or workman-
ship. Repairs or replacements are warranted as described above for the duration of the original warranty period. In the unlikely
event a replacement unit is required during this One (1) year period, return the unit to your local NAPA Auto Parts Store for a
replacement. This warranty does not apply to products which have been subjected to abuse, misuse, modification, neglect, lack of
maintenance, use in a production-related service, or repaired by anyone other than an Authorized Carlyle Air Tool Service Center.
For complete listing of Authorized Master Repair Centers, see enclosed Customer Warranty Repair Form, or
visit www.toolwarrantyrepair.com
6-754A
When using the Die Grinder, be careful
not to exert excessive force which could
be hazardous and cause mounted spindle
to bend or break.
NOTE: During operation, safety gog-
gles should always be worn to guard
against flying debris (users and
point
bystanders).
Correct bonded abrasive mounted
point grinding wheels, rotary files and
carbide burrs are necessary to prevent
injury from broken accessories. Do not
use chipped or cracked bonded abra-
sive mounted point grinding wheels,
rotary files and carbide burrs. Tighten
the bonded abrasive mounted point
grinding wheels, rotary files and car-
bide burrs on the collet to prevent spin
off when the Die Grinder is turned off.
Never mount a grinding wheel, cut-
offwheel, router cutter or drill bit on a
Die Grinder.
Never use an arbor, mandrel or any
other adaptor to convert the Die
Grinder for any other application.
Air Regulator
This Carlyle Air Tool is warranted against defects in material and workmanship for a period of One (1) Year

Specifications

Horsepower .............................. 0.5HP
Overall Length ................................ 7"
Width ......................................... 2.76"
Weight .................................... 1.3 lbs.
RPM ................................ 22,000 RPM
Collet ........................................... 1/4"
Sound Level ............................ 82dBa
Vibration Level ....................... 0.5m/s2
Air Consumption ................... 3.1CFM
Air Inlet Thread Size .......1/4"-18 NPT
Recommended Hose Size ....3/8" I.D.
Recommended
Air Pressure ................. 90psi (6.2 bar)
Air Inlet
5 Rev. 09/09/19