HIKOKI UM 36DA Handling Instructions Manual

HIKOKI UM 36DA Handling Instructions Manual

Mixer bare uni
Hide thumbs Also See for UM 36DA:

Advertisement

Quick Links

UM 36DA
Handling instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UM 36DA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HIKOKI UM 36DA

  • Page 1 UM 36DA Handling instructions...
  • Page 3 Lock...
  • Page 6: General Power Tool Safety Warnings

    c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off -position before connecting WARNINGS to power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your fi nger on the switch Read all safety warnings, instructions, illustrations and or energising power tools that have the switch on specifi...
  • Page 7: Additional Safety Warnings

    Slippery handles and grasping surfaces do not 6. Bring the battery to the shop from which it was purchased allow for safe handling and control of the tool in as soon as the post-charging battery life becomes too unexpected situations. short for practical use.
  • Page 8: Caution On Lithium-Ion Battery

    6. Do not reach into the mixing container with your 3. Do not use an apparently damaged or deformed battery. hands or insert any other objects into it while 4. Do not use the battery in reverse polarity. mixing. 5. Do not connect directly to an electrical outlets or car Contact with the mixer basket may lead to serious cigarette lighter sockets.
  • Page 9 Battery level indicator switch Power Output Battery level indicator lamp Arrow 2 to 3 digit number Double-ended wrench (17, 22 mm) Double-ended wrench (17, 19 mm) Latch Rubber cover USB DEVICE CONNECTION USB port PRECAUTIONS (UC18YSL3) USB cable When an unexpected problem occurs, the data in a USB device connected to this product may be corrupted or lost.
  • Page 10: Standard Accessories

    ○ Overload protection NOTE This protection feature cuts off the power to the motor Due to HiKOKI’s continuing program of research and in the event of overloading of motor or a conspicuous development, the specifi cations herein are subject to reduction in rotational speed during operation.
  • Page 11 CHARGING 2. Battery Model BSL36A18 BSL36B18 Before using the power tool, charge the battery as follows. 36 V / 18 V (Automatic Switching*) Voltage 1. Connect the charger’s power cord to the receptacle. When connecting the plug of the charger to a receptacle, 2.5 Ah / 5.0 Ah 4.0 Ah / 8.0 Ah the charge indicator lamp will blink in red (At 1- second...
  • Page 12: Mounting And Operation

    (2) Regarding the temperatures and charging time of the rechargeable battery The temperatures and charging time will become as shown in Table 2. Table 2 Charger UC18YSL3 Type of battery Li-ion Temperatures at which the 0°C–50°C battery can be recharged Charging voltage 14.4 Multi volt...
  • Page 13: Maintenance And Inspection

    ○ Place the mixing screw inside the container and check for safety before turning on the switch. Important notice on the batteries for the HiKOKI Once mixing is complete, wait for the mixing screw to cordless power tools come to a complete stop before removing it from the container.
  • Page 14: Troubleshooting

    TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. 1. Power tool Symptom Possible cause Remedy Does not move No battery remaining.
  • Page 15 The charger’s vents are blocked, causing its Avoid blocking the vents. internal components to overheat. The cooling fan is not running. Contact a HiKOKI Authorized Service Center for repairs. The USB power lamp The battery’s capacity has become low. Replace the battery with one that has has switched off...
  • Page 16 UM36DA (XC) (NN) ― BSL36A18 ― UC18YSL3 ―...
  • Page 17 UC18YSL3 (14.4V–18V) BSL36A18 BSL36C18 BSL36B18 329897...
  • Page 20 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99737811 G Printed in China...

Table of Contents