Gigabyte B460M H User Manual page 40

A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the Boot menu is disabled.
2. Go to Settings\IO Ports\SATA And RST Configuration and make sure USE RST Legacy OROM is disabled
and RST Control PCIe Storage Devices is set to Manual. If you want to enable the Optane
in the M.2 connector, set PCIe Storage Device on Port 21 to RST Controlled.
3. Enter the operating system, launch the Intel
enable Intel Optane Memory on the Intel
® ™
4. Launch the Intel Rapid Storage Technology utility from the Start menu and make sure the Intel
®
Memory has been enabled. If you want to accelerate the system drive, you can select specific folders, files, or
applications to accelerate using the Intel
used must have at least 32 GB capacity.)
• An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
™
• Do not abruptly remove the Optane
functioning correctly.
• If you want to change/remove the Optane
Storage Technology or Intel(R) Optane
• After enabling the Optane
Rapid Storage Technology utility from the Start menu, and then
®
Optane Memory screen.
® ™
Optane Memory Pinning function. (The Intel
® ™
memory. Doing so will cause the operating system to stop
™
memory, you must disable it using the Intel
™
Memory application first.
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 40 -
memory installed
™
Optane
® ™
Optane memory
® ™
Rapid
®