Table of Contents
Advertisement
DEBUG
PORT
5) LED_C (RGB LED Strip Header)
The header can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
_
6) M2M_SB (M.2 Socket 3 Connector)
The M.2 connector supports M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. Please
note that an M.2 PCIe SSD cannot be used to create a RAID set with a SATA hard drive. To create a RAID
array with an M.2 PCIe SSD, you must set up the configuration in UEFI BIOS mode. Refer to Chapter 3,
"Configuring a RAID Set," for instructions on configuring a RAID array.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Locate the proper mounting hole for the M.2 SSD to be installed and then install the mounting clip first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it by pressing the clip pin into the mounting hole.
1
Pin No. Definition
F
RGB
LED Strip
Connect your RGB LED strip to the header. The power pin (marked with a
_ 0
triangle on the plug) of the LED strip must be connected to Pin 1 (12V) of
1
this header. Incorrect connection may lead to the damage of the LED strip.
12V
For how to turn on/off the lights of the LED strip please visit the "Unique Features" webpage of
GIGABYTE's website.
_ F
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
_ 0
F
80
60
42
_3
U
Select the proper hole for the M.2 SSD to be installed and refasten the screw and standoff.
S
S
1
12V
2
G
3
R
4
B
- 14 -
Advertisement
Table of Contents
