Gigabyte Z490M User Manual page 11

HDMI Port
maximum supported resolution is 4096x2160@30 Hz, but the actual resolutions supported are
dependent on the monitor being used.
• To set up a triple-display configuration, you must install motherboard drivers in the operating system first.
• After installing the DisplayPort/HDMI device, make sure to set the default sound playback device to DisplayPort/
HDMI. (The item name may differ depending on your operating system.)
USB 3.2 Gen 2 Type-A Port (Red)
The USB 3.2 Gen 2 Type-A port supports the USB 3.2 Gen 2 specification and is compatible to the USB
3.2 Gen 1 and USB 2.0 specification. Use this port for USB devices.
USB Type-C Port
™
The reversible USB port supports the USB 3.2 Gen 1 specification and is compatible to the USB 2.0
specification. Use this port for USB devices.
RJ-45 LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Connection/Speed LED:
Speed LED Activity LED
LAN Port
USB 3.2 Gen 1 Port (Q-Flash Plus Port)
The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specification and is compatible to the USB 2.0
specification. Use this port for USB devices. Before using Q-Flash Plus
USB flash drive into this port first.
Line In/Rear Speaker Out (Blue)
The line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
Line Out/Front Speaker Out (Green)
The line out jack.
Mic In/Center/Subwoofer Speaker Out (Pink)
The Mic in jack.
Audio Jack Configurations:
Jack
Line In/Rear Speaker Out
Line Out/Front Speaker Out
Mic In/Center/Subwoofer Speaker Out
Front Panel Line Out/Side Speaker Out
(Note) To enable the Q-Flash Plus function please visit the "Unique Features" webpage of GIGABYTE's website.
Please visit GIGABYTE's website for details on configuring the audio software.
The HDMI port supports HDCP 2.3 and Dolby TrueHD and DTS HD Master
Audio formats. It also supports up to 192KHz/16bit 7.1-channel LPCM audio
output. You can use this port to connect your HDMI-supported monitor. The
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
Headphone/
2-channel
a
- 11 -
Activity LED:
State Description
Blinking Data transmission or receiving is occurring
On No data transmission or receiving is occurring
, make sure to insert the
(Note)
4-channel 5.1-channel
a a
a a
a
7.1-channel
a
a
a
a