Gigabyte H470 HD3 User Manual page 20

_ U
_
F_USB3 F
15) SPI_TPM (Trusted Platform Module Header)
_ _B
You may connect an SPI TPM (Trusted Platform Module) to this header.
_B _
16) THB_C1/THB_C2 (Thunderbolt
S F_
The connectors are used to connect to a GIGABYTE Thunderbolt
S F_
B
B_
B
17) CLR_CMOS (Clear CMOS Jumper)
F_USB3
Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear
the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.
F_USB30 3
F_USB3 F
B
_ S _
S _
11 1
12 2
B_
1
1
THB_C2 THB_C1
F_USB30 3
Open: Normal
Short: Clear CMOS Values
• Always turn off your computer and unplug the power cord from the power outlet before clearing
the CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
F
_ 0
Pin No. Definition Pin No. Definition
1 7
Data Output
2 8
Power (3.3V)
_ F
3 9
No Pin
4 10
NC
5 11
Data Input
6 12
CLK
_ 0
Add-in Card Connectors)
™
Supports a Thunderbolt
™
_3 U
- 20 -
_ 0
_ F
Chip Select
GND
IRQ
NC
NC
_ 0 F
RST
F
add-in card.
™
add-in card.
_3 U