Gigabyte H470 HD3 User Manual page 16

B
S B_
B
S B_
B
_ S
S_ 7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
_
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
B
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
_ S
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
_ U a RAID array.
S_
_
_
B
B
USB3 F
_ U
_
B
F_USB3 F
S _
_ S _
8) M2M_SB/M2P_SB (M.2 Socket 3 Connectors)
The M.2 connectors support M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. Please
note that an M.2 PCIe SSD cannot be used to create a RAID set either with an M.2 SATA SSD or a SATA
hard drive. To create a RAID array with an M.2 PCIe SSD, you must set up the configuration in UEFI BIOS
mode. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Use a screw driver to unfasten the screw and standoff from the motherboard. Locate the proper mounting
hole for the M.2 SSD to be installed and then screw the standoff first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it with the screw.
B
SATA3
5 3 1
4 2 0
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATA And RST Configuration," for more information.
110 80 60
80 60
_3
F
Pin No. Definition
1 GND
2 TXP
3 TXN
F
1
4 GND
_ 0
5 RXN
1
6 RXP
7 GND
_ 0
_ F
_ F
_ 0 F
_ 0 F
M2M_SB
42
M2P_SB
42
U
_3 U
- 16 -
S
S
S
S
Chipset supports RAID 0,
®