Before using for the first time
3. Removing the transit bars
Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing
machine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation".
The following message appears in the
display:
Remove transit bars
Confirm with the OK sensor.
4. Starting the calibration
programme
For optimum water and energy
consumption and excellent wash
results, it is important to calibrate the
washing machine.
To do this, the Cottons programme
must be run without laundry and
without detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Open and run 'Cottons' 90°C without
laundry
Touch the sensor until the
OK sensor lights up and confirm with
OK.
90°
1400
20
Turn on the tap.
Touch the Start/Add laundry sensor.
The calibration programme will start. It
will take approximately 2 hours.
At the end of the programme the
following message will appear in the
display:
Take hold of the door and pull it
Useful tip: For safety reasons, close the
door when the washing machine is not
in use. Otherwise there is a danger of
objects being placed inadvertently in
the drum. If these remain unnoticed and
were washed in the next load, they
could damage the laundry. An open
door is also a danger to pets and
children.
Turn the programme selector to the
1:55
OK
Set up completed
open.
position.