Installation Instructions; Preparing The Enclosure; Required Tools - Danby DWC134KD1BSS Owner's Manual

INSTALLATION INSTRUCTIONS

PREPARING THE ENCLOSURE

Gloves and safety goggles should be worn during
installation.
It is not recommended to install the appliance into a
corner or directly beside a wall. The door will need
to be opened more than 90° to allow full extension
of the shelves. If it is necessary to place the unit next
to a wall or in a corner, leave at least 5-10 cm of
space between the wall and the appliance to allow
for the door opening.
The cabinet opening must be at least 61.5 cm wide
by 83 cm high by 59 cm deep.
Note: The listed depth requirement is assuming
that the electrical outlet is located in the adjacent
cabinetry or fl ush mounted in the rear wall, not
surface mounted inside the enclosure.
If the electrical outlet is located inside adjacent
cabinetry, cut a 3.8 cm diameter hole to admit the
power cord. If the cabinet wall is metal, the hole
edge must be covered with a bushing or grommet.
See image below.
3.8 cm diameter
83 cm
*If electrical outlet in
adjacent cabinetry
Electrical Access Electrical Access
59 cm
61.5 cm

REQUIRED TOOLS

• Safety goggles
• Gloves
• Tape measure
• Carpenter square
• Level
• Flashlight
• Electric drill with hole bit
Safety goggles
Electric drill with hole bit
Gloves
5 cm
15.2 cm
90°
3
Tape measure
Carpenter square
Flashlight
Level