Table of Contents
Advertisement
FCC Class B
Radio Frequency Interference State-
ment
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
dential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one or
more of the following measures:
1.
Reorient or relocate the receiving antenna.
2.
In crease the separation between the
equipment and receiver.
3.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
4.
Consult the dealer or an experienced
radio/television technician for help.
Notice:
The changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user's authority to operate
the equipment.
Caution:
1.
If you find some parts of the monitor
display discolored due to magnetic fields
generated by electrical facilities or
appliances, turn off the monitor for at least
15 minutes. The degaussing circuit of the
monitor will eliminate the discoloration.
2.
Do not remove the monitor from its swivel
base while the power is on to prevent
discoloration.
If discoloration occurs,
follow the above-mentioned procedure for
adjustment.
3.
Shielded power cord and interface cable, if
any, must be used in order to comply with
the emission limits of FCC Class B digital
device.
FCC Class B 7
Advertisement
Table of Contents
