Table of Contents
Advertisement
Hinge supports
1
Detergent dispenser
2
Control panel
3
Magnetic plate
4
Door handle
5
Rating plate
6
Plate with rubber beater
7
A
B
Mod. xxxxxxxxx
Prod.No.
C
000V ~ 00Hz 0000 W
D
4. TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
1)
Water supply
Maximum Load
Spin Speed
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar).
If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic sys‐
tem, connect it to your domestic cold water storage system. Make sure not to exceed a dis‐
tance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water stor‐
age tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.
5. INSTALLATION
WARNING!
Refer to Safety chapters.
910000000 00
00A
00000000
Width/ Height/ Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
2)
Cotton
Maximum spin speed
Drain pump filter
8
Front feet for levelling the appliance
9
Drain hose
10
Mains cable
11
Inlet hose connection
12
Back feet for levelling the appliance
13
The rating plate reports the model name
(A), product number (B), electrical ratings
(C) and serial number (D).
59.6 cm /81.9 cm /55.3 cm
230-240 V
2200 W
13 A
50 Hz
IPX4
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
7 kg
1151 rpm
5.1 Be prepared for installation
It is recommended that
installation is carried out by
two persons.
ENGLISH
7
Advertisement
Table of Contents
