Whispbar K541W Fitting Instructions Manual page 8

Basic carrier fitting kit

Hide thumbs Also See for K541W:

Table of Contents

Available languages

Fitting Kit

K541W

Fitment

Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

Please check the rear of this manual for

information relating specifically to your

vehicle.

Locate vehicle's fixed points.

Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

Clamps directly to edge of roof under the

doors, pin locates in hole on vehicle

Tighten adjusting screw to 5 Nm (3.7 ft lb).

Table of Contents

Need help?

Do you have a question about the K541W and is the answer not in the manual?