Profile LONTANO Manual page 21

1
PROGRAMMING
A
B
BEEP BEEP
♫ ♫
C
NOTE :
The bell unit will store every programmed button, even if you remove the batteries from the bell
unit. When the memory of the bell unit is full, a four-tone ringtone will play. To set a new button
you must remove the programme.
2
DELETE PROGRAMME
3
PROGRAMMING MULTIPLE BELLS
Repeat steps 1A - 1C for all bells. Do this per bell in order to avoid interference. You can call pro-
gramme up to x bells per button.
Access the button by pressing in the tab on the side and
removing the insulating strip.
Slide open the lid on the back. Insert 2 alkaline batteries
into the battery compartment. The bell will not make a
sound. The bell is ready to learn and memorise the digital
code.
Within one minute, push the button. The bell will play a
ringtone. It has now been programmed and stored (even if
the batteries are removed). Leave it for 5 minutes before
reusing it.
To delete a programme remove the batteries from the bell.
Press the channel selection button and simultaneously
place the batteries back in the bell unit. It is important to
keep the channel selection button pressed.
The bell unit will play a two-tone ringtone. All buttons have
been deleted from the memory and the bell unit is ready to
read a new button.
UK