Advertisement
C WASHABLE CLEANING (F555)
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Pull the foil assembly up to remove from hair pocket.
• Foils – do not use the brush to clean the foils. Instead, blow the shavings out or rinse the
foils under cold water or warm water.
• Cutters & Trimmers – Use the cleaning brush to sweep any loose hairs from the cutter
and trimmer. Rinse them in cold or warm water. Do not use hot water.
• After cleaning, replace the head assembly.
• Replace head assembly.
A CAUTION
Never submerge your shaver completely under water.
C TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
,
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that
foils and cutters are replaced regularly.
,
SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter
pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
,
TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert new foil assembly in hair pocket until it snaps into place.
,
TO REPLACE THE CUTTERS
• Grasp cutter between thumb and forefinger and pull forward.
• Snap both new cutter assemblies into top of oscillator tips.
Note: DO NOT press on the cutter ends as this may cause damage.
Foil replacement model: SP-200
Replacement parts and accessories available to buy at http://www.remington.co.uk/
parts-accessories
5
Advertisement
