Advertisement
4.2.
Air Line Couplings.
Vibration may cause failure if a quick change coupling is connected directly to screwdriver. To overcome this, connect a leader hose to
the screwdriver. A quick change coupling may then be used to connect the leader hose to the air line recoil hose. See fig.1 & fig.2.
fig.1
4.3.
Air Pistol Driver
WARNING! Ensure you read, understand and apply safety instructions before use.
4.3.1.
Push the chuck collar forward (fig.3) and insert driver bit into the chuck. To release the bit, push chuck collar forward and pull bit out.
4.3.2.
Connect the screwdriver to the air hose as in fig.1 and fig.2.
4.3.3.
The screwdriver direction is changed by switching the thumb control on the side of the screwdriver (fig.3A).
4.3.4.
Check that the screwdriver is set to operate in the required direction.
4.3.5.
Depress the trigger to operate the screwdriver accordingly. DO NOT allow the screwdriver to free run for an extended period of time
as this will shorten its life.
4.3.6.
Regulate the air pressure to the driver to obtain optimum torque for the task.
5. MAINTENANCE
WARNING! Disconnect the screwdriver from air supply before changing accessories, servicing or performing maintenance. Replace or
repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
5.1.
Lubricate the air screwdriver daily with a few drops of Sealey air tool oil dripped into the air inlet to prolong its life.
5.2.
Clean the screwdriver after use.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To remedy check the
air supply and follow instructions in 4.1.
b) Grit or gum deposits in the screwdriver may also reduce performance. If your model has an air strainer (located in the area of the air
inlet), remove the strainer and clean it. Flush the screwdriver out with gum solvent oil or an equal mixture of SAE No 10 oil and
paraffin. Allow to dry before use.
5.4.
For a full service contact your local Sealey service agent.
5.5.
When not in use, disconnect from air supply, clean screwdriver and store in a safe, dry, childproof location.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, dispose of the product according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
fig.3
Environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
fig.2
01284 757500
www.sealey.co.uk
sales@sealey.co.uk
01284 703534
SA623_V2 Issue: 2(SP) - 03/11/15
Advertisement
