Page 2
Please pass these instructions on to the end user of the fitting! S.v.p remettre cette instruction à l'utilisateur de la robinetterie! Entregue estas instrucciones al usario final de la grifería!
Page 5
English Installation 7. Screw on sleeves (J1) for diverter (J), see Fig. [4]. 8. Grease seal (K) with the grease provided, slide the 1. Remove the two screws (A1) from the fitting template (A), escutcheon mounting base (L) on and tighten with then remove the template, see Fig.
Page 7
English Maximum hot water limit setting 5. Align the white mark (D1) on the limit stop against the number (1 to 10, see Fig. [6]) you have selected on the dial The adjustable hot water limit stop (D) is factory set in a and slide the limit stop (D), see Fig.
Page 9
English Maintenance If the check valves are removed it is important to reinstall them Check, clean and if necessary, replace parts. Grease with with the O-ring facing away from the cartridge. If they are special valve grease. installed incorrectly no water will flow. The pressure balancing cartridge (V) must be replaced as a I.