Do you have a question about the Atrio 19 395 and is the answer not in the manual?
Questions and answers
Barry James Hurley
February 3, 2025
The top tap of a Grohe 19 295 is slightly wobbling. how do I tighten it. Does the three pronged operating tap pull off to enable the tightening to taake place?
1 comments:
Mr. Anderson
February 10, 2025
To tighten the top tap of a Grohe Atrio 19 395 if it is wobbling, follow these steps:
1. Remove the handle: The three-pronged operating tap (handle) should pull off. If it does not come off easily, check for a hidden screw securing it in place and loosen it if necessary. 2. Check the splined adapter (J): Ensure that the splined adapter is properly aligned and securely attached. 3. Tighten the screw ring (Y): Use a 34mm tool to tighten the screw ring if it has loosened. 4. Reassemble: Once tightened, reattach the handle (P) and ensure it is securely in place.
These steps should stabilize the tap and prevent it from wobbling.
Page 2
19 395 19 399 19 399 19 395 35 500 Bitte diese Anleitung an den Benutzer der Armatur weitergeben! Please pass these instructions on to the end user of the fitting. S.v.p remettre cette instruction à l'utilisateur de la robinetterie! *19 332...
Adjusting Installation of the temperature control handle (R) and Installation temperature adjustment, see fold-out page II, Figs. [8] and [9]. • Before the mixer is put into service, if the mixed water temperature measured at the point of discharge varies from Always take care with the concealed mixer the specified temperature set on the thermostat.
Need help?
Do you have a question about the Atrio 19 395 and is the answer not in the manual?
Questions and answers
The top tap of a Grohe 19 295 is slightly wobbling. how do I tighten it. Does the three pronged operating tap pull off to enable the tightening to taake place?
To tighten the top tap of a Grohe Atrio 19 395 if it is wobbling, follow these steps:
1. Remove the handle: The three-pronged operating tap (handle) should pull off. If it does not come off easily, check for a hidden screw securing it in place and loosen it if necessary.
2. Check the splined adapter (J): Ensure that the splined adapter is properly aligned and securely attached.
3. Tighten the screw ring (Y): Use a 34mm tool to tighten the screw ring if it has loosened.
4. Reassemble: Once tightened, reattach the handle (P) and ensure it is securely in place.
These steps should stabilize the tap and prevent it from wobbling.
This answer is automatically generated