Table of Contents
Advertisement
4. Put the front polystyrene packaging
element on the floor under the
appliance. Carefully put down the
appliance onto its rear side.
5. Remove the polystyrene protection
from the bottom. Put the appliance
back into an upright position.
6. Remove the power supply cable and
the drain hose from the hose holders.
1
2
It is possible to see
water flowing from the
drain hose. This is
because the washing
machine has been
tested at the factory.
7. Remove the three transit bolts and
pull out the plastic spacers.
8. Put the plastic caps, that you find in
the user manual bag, in the holes.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.
3.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
ENGLISH
7
Advertisement
Table of Contents
