Advertisement
4.
OPERATING INSTRUCTIONS
WARNING! Ensure that you read, understand and apply the
safety instructions before use.
4.1.
ASSEMbLY
4.1.1. The SA152 comes with a handle and a spanner.
4.1.2. The handle screws into the left-hand side of the head.
4.1.3. Remove the disc locking flange nut from the grinder spindle.
Use the spindle stop button and the spanner supplied to hold
the spindle and loosen/tighten the lock nut.
4.1.4. Fit the grinding disc over the spindle (with the protruding side downwards) and retain it with the flange
nut. Use only discs with speed ratings equal to, or higher than, the speed rating of the grinder.
4.1.5. Connect air supply to grinder and squeeze the control valve lever to check that the grinder is working
correctly.
4.2.
OPERATING
DO NOT apply excessive pressure, let the grinder do the work for you. Start the grinder and bring the
disc to the the work surface evenly and slowly. Move the grinder back and forth in overlapping areas.
Remove the grinding disc from the work surface before stopping the grinder. Regularly check the
condition of the disc and always change if worn, cracked or otherwise damaged.
DO NOT run the grinder off the workpiece for extended periods. This will shorten the life of the bearings.
5.
MAINTENANCE
WARNING! Disconnect the grinder from air supply before changing the disc, servicing or
performing maintenance.Replace or repair damaged parts. Use genuine parts only. Unauthorised
parts may be dangerous and will invalidate the warranty.
5.1.
lubricate the grinder daily with a few drops of good grade air tool oil, such as Sealey ATO/500 or
ATO/1000, dripped into the air inlet before use or dispensed automatically through an air system oiler,
such as Sealey model SA100l or SA2001/l.
5.2.
Clean the grinder after use and change the disc when worn or damaged.
5.3.
loss of power or erratic action may be due to the following:
a) Excessive drain on the air supply. Moisture or restriction in the air line. Incorrect size or type of
hose connectors. To remedy, check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the grinder may also reduce performance. Flush the grinder with gum
solvent oil or an equal mixture of SAE No 10 oil and kerosene. Allow to dry before use.
If you continue to experience problems, contact your local Sealey service agent.
5.4.
When not in use, disconnect from air supply, clean grinder and store in a safe, dry, childproof location.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey limited
ENVIRONMENTAL PROTECTION
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
Web
01284 703534
email
SA152.V2 Issue:3(SP)- 02/01/14
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
