Advertisement
Operating Instructions
MaxLite LED Small Flood Fixtures
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or
maintenance of the luminaires, consult a qualified licensed electrician
and check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
WARNING:
• Risk of Fire - Supply conductors (power wires) connecting the fixture
must be rated minimum 90 . If uncertain consult an electrician.
• Risk of fire or electric shock. installation requires knowledge of
luminaires electrical systems.
• Risk of Fire/Electric Shock - If not qualified, do not attempt installation. Contact a qualified electrician.
• Do not use in high humidity conditions.
• Keep away from flammable and explosive environment.
• Don't cover the fixture with insulation liner or similar material.
• Don't install where fixture is loose or only partially supported.
• Don't impact or exert pressure on the fixture surface face or rear, as damage may occur.
CAUTION:
• For your safety read and understand instructions completely before starting installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects.
• Before attempting installation, check your local electrical code, as it
sets the wiring standards for your locality.
NOTES:
• If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire is
connected to the switch. DO NOT connect the white supply wire to the switch.
• Make certain no bare wires are exposed outside the wire nut connectors.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during
kit installation.
Model:
FLSxx/G2 Series
Operating characteristics:
Operating temperature: -30°C to 40°C
Input voltage range: 120-277V 50/60 HZ
FLS Series
Picture is for illustration purposes only.
Your model may vary.
Page: 1
REV: 8/02/18
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MaxLite FLS Series
Summary of Contents for MaxLite FLS Series
- Page 1 Operating Instructions FLS Series MaxLite LED Small Flood Fixtures ® General Safety Information • To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
- Page 2 Operating Instructions FLS Series MaxLite LED Small Flood Fixtures ® Installation Instructions 3.) Using a wrench, adjust luminaire to desired 1.) Inspect components to ensure that male and female port threads and sealing surfaces are free aiming angle and tighten screw (Fig. 3) of burs, nicks and scratches or any foreign material.
- Page 3 Operating Instructions FLS Series MaxLite LED Small Flood Fixtures ® Installation Instructions (Continued) 6.) For models with a photocell: Remove black sensor cap to use the photocell. If no photocell is needed the cap can be left in place. WARNING: For models with photocell, please make sure the photocell is on the top.
- Page 4 MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with the same or like Product.
Need help?
Do you have a question about the FLS Series and is the answer not in the manual?
Questions and answers