Epson WorkForce WF-2850 User Manual page 234

LCD screen message
To use cloud services, update the
root certificate from the Epson Web
Config utility.
Check that the printer driver is
installed on the computer and that
the port settings for the printer are
correct.
Check that the printer driver is
installed on the computer and that
the USB port settings for the printer
are correct.
Recovery mode
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic: Solving Problems
Related references
Where to Get Help
Paper Source Settings Options
Related tasks
Using AirPrint
Selecting the Line Type
Checking for Software Updates
Accessing the Web Config Utility
Condition/solution
Access the Web Config utility and update the cloud service root
certificate.
Make sure the printer port is correctly configured. In Windows,
make sure the port is set to a USBXXX setting for a USB
connection or EpsonNet Print Port for a network connection.
An error has occurred during firmware updating. Connect your
product using a USB cable and try downloading the Firmware
Update from the Epson support site. If you still need help,
contact Epson for support.
234