Table of Contents
Advertisement
1
B160S
ATTENTION!
Please ensure that the B160S is powered off or unplugged from the mains power outlet before making any connections. It is also advisable to power
down or unplug all associated components while breaking any signal or AC power connections.
1
STATUS INDICATOR
Below is a table of the LED blink codes and their corresponding
descriptions.
LED BLINK
Short blue flash, then red
Alternate flashing red and green
Flashing green
Solid red
Red pulse
Flashing red
Solid white
White pulse
Solid blue
Flashing blue
2 LAN/USB
LAN
• LAN connection must be setup for wired connection to be
established. Set up a Wired Ethernet broadband router with
broadband internet connection. Your router or home network
should have a built-in DHCP server to consummate the
connection.
• Using a standard straight-through Ethernet cable (not supplied),
connect one end of the Ethernet cable to the LAN port of your
wired Ethernet broadband router and the other end to B160S'
LAN port.
CODE DESCRIPTION
Powering up, rebooting the unit
Upgrading...
Connecting to network shares
Cannot boot; drive error
Upgrade mode
No internet gateway
Factory reset in progress
Indexing
Software update available
Connected to Network – ready to use
with Bluesound App
Mute mode
IDENTIFICATION OF CONTROLS
2
LAN/
USB
4
RESET
SERVICE
6
IR IN
8
100-120V/220-240V
10
NOTES
• Bluesound Professional is not responsible for any malfunction of the
B160S and/or the internet connection due to communication errors
or malfunctions associated with your broadband internet connection
or other connected equipment. Contact your Internet Service Provider
(ISP) for assistance or the service bureau of your other equipment.
• Contact your ISP for policies, charges, content restrictions, service
limitations, bandwidth, repair and other related issues pertinent to
internet connectivity.
USB
• Connect to this USB port USB mass storage devices formatted as
FAT32, NTFS or Linux ext4. The connected USB device appears
as a Local Source (USB) in the BluOS App.
• Access and playback music stored in the connected USB device
by selecting "USB" from the BluOS App
3 SPEAKER OUT
• Connect external speaker cables to supplied SPEAKER terminal
block ensuring that the connections match B160S' SPEAKER
OUT terminal markings.
• Ensure that SPEAKER OUT "R+" is connected to the "+" terminal
of your external right speaker and SPEAKER OUT "R-" connected
to the speaker's "-" terminal. Connect SPEAKER OUT terminals
marked "L+" and "L-" to the external left speaker in the same
way.
• Install the wired up SPEAKER terminal block to B160S'
SPEAKER OUT terminal.
SPEAKER OUT
3
LINE / MIC IN
R
5
L
7
SUBW
OUT
PHANTOM
9
ON
OFF
MIC LINE
50/60Hz
5
Advertisement
Table of Contents
