Advertisement
Step 4.
• Install the front and rear stabilizer covers (32 & 37) and secure to the
frame with four screws (99).
• Install the left and right cup holders (39 & 38) to the rear handlebars
with four screws (105).
• Install the bottom seat cushion (61) to the seat carriage (4) with four
screws (186).
• Install the Pedals (116 L, 117 R) into the Crank arms (51L, 51R).
Remember that the left pedal has a reverse thread and will be screwed
into the crank in the opposite rotation from normal threads. There is an
"L" stamped into the end of the threaded post of the left pedal and an
"R" in the right. Make sure to tighten the pedals as much as you
possibly can. It may be necessary to re-tighten the pedals if you feel a
thumping during pedaling the bike. A clicking noise, or thumping,
sound during pedaling is usually caused by the pedals being too loose.
• Connect the two wire harnesses (44 & 45) to the corresponding
connectors on the back of the console. Install the console onto the
console mast and secure with four screws (99) being careful and not
pinch the wires.
• Attach the console chin (125) cover on the console mast (2) with two
screws (99).
Hardware for step 4
Part
Type
99
Phillips head screw
105
Sheet metal screw
186
Phillips head screw
Description
Qty
M5 × 12m/m
4 × 16m/m
M6 × 18m/m
14
10
4
4
Advertisement
