Bestway FLOWCLEAR 58391 Owner's Manual page 5

P6916
PEDESTAL FIXING Fig.1
The filter pump must be vertically fixed on ground or a certain pedestal made of wood or
concrete before use. There should be two holes 9mm in diameter on the pedestal, the
space between which should be 212mm. Put filter pump on the pedestal and fix them
together by fasten the bolts and nuts. All the pedestal parts should weigh over 18kgs at
least to prevent the pump from accidental falling.
Operation
1) Open/unscrew the Air Purge Valves (P6112 and P6030) on the Filter Pump; Air is released as water fills the Filter Pump.
2) When water comes out of the Air Purge Valves (P6112 and P6030), screw it closed and wipe away any water.
3) To start the Filter Pump, Insert the plug into a residual current device (RCD).
4) Turn on the switch to the "I" position.
IMPORTANT: DO NOT DRY RUN THE FILTER PUMP - Make
sure both the pool's Inlet and Outlet valves are fully covered by
water before operating the Filter Pump.
PUMP MAINTENANCE
CAUTION: YOU MUST ENSURE THE FILTER PUMP IS
UNPLUGGED BEFORE ANY MAINTENANCE BEGINS OR
SEVERE RISK OF INJURY OR DEATH EXISTS.
1) Unplug the Filter Pump.
2) Stop water flowing to the Filter Pump refer to pool's manual.
3) Unscrew the Filter Cap Retainer and remove the Filter Cap.
4) Clean the Filter Cartridge with a garden hose.
5) Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump.
6) Check that the Filter Cap Seal is in place.
7) Replace the Filter Cap and screw the Filter Cap Retainer into position.
8) Open the valve A and B.
9) Follow Pump Installation Directions section to prepare the system for use.
IMPORTANT: For sanitary reasons we suggest replacing the Filter
Cartridge with a new one every two weeks. Flush the filter daily.
Winterization and long-term storage
1) Unplug the Filter Pump.
2) Stop water flowing into the Filter Pump and to remove the Filter Cartridge.
3) Discard the Filter Cartridge.
4) Detach all Hoses.
5) Dry all components thoroughly.
6) Store the filter pump in a dry location out of child's reach. Storage temperature: 4-40°C (39.2-104°F)
7) Drain the pool according to the Pool Owner's Manual.
Pump Warranty
For information concerning pump warranty please visit our website at: www.bestwaycorp.com
B
A
P61318
P6680
5
2-M8 nut
2-M8 bolt
S-S-004243
Fig.1