Bestway FlowClear 58389 Owner's Manual page 7

Filter pump

Hide thumbs Also See for FlowClear 58389:

NOTE: It is imperative to check that the hydraulic connectors

are not obturated.

Operation

1) Open/unscrew the Air Purge Valve (P6112) on the top of the Filter Pump; air is released as water fills the Filter Pump.

2) When water comes out of the Air Purge Valve (P6112) screw it closed and wipe away any water.

3) To start the Filter Pump, insert the plug into a residual current device (RCD).

IMPORTANT: DO NOT DRY RUN THE FILTER PUMP - Make

sure both the pool's Inlet and Outlet valves are fully covered by

water before operating the Filter Pump.

PUMP MAINTENANCE

CAUTION: YOU MUST ENSURE THE FILTER PUMP IS

UNPLUGGED BEFORE ANY MAINTENANCE BEGINS OR

SEVERE RISK OF INJURY OR DEATH EXISTS.

1) Unplug the Filter Pump.

2) Stop water flowing to the Filter Pump refer to pool's manual.

3) Unscrew the Filter Cap Retainer and remove the Filter Cap.

4) Clean the Filter Cartridge with a garden hose.

5) Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump.

6) Check that the Filter Cap Seal is in place.

7) Replace the Filter Cap and screw the Filter Cap Retainer into position.

8) Open the valve A and B.

9) Follow Pump Installation Directions section to prepare the system for use.

IMPORTANT: For sanitary reasons we suggest replacing the Filter

Cartridge with a new one every two weeks. Flush the filter daily.

Winterization and long-term storage

1) Unplug the Filter Pump.

2) Stop water flowing into the Filter Pump and to remove the Filter Cartridge.

3) Discard the Filter Cartridge.

4) Detach all Hoses.

5) Dry all components thoroughly.

6) Store the filter pump in a dry location out of child's reach.Storage temperature: 4-40°C (39.2-104°F)

7) Drain the pool according to the Pool Owner's Manual.

Pump Warranty

For information concerning pump warranty please visit our website at: www.bestwaycorp.com

S-S-004237