Advertisement
NP40 Numeric Pager
Hand Programming Manual
• Turn the pager off by pressing the
Menu Key.
• Using the
Menu Key, scroll through the various options until "Pager Off" is found.
• Press the
Read Key to select this menu item. The pager will then turn off.
• Remove the battery from the pager.
• Now hold down both the
Menu Key and the
Read Key while inserting the
battery into the pager.
• You may be prompted for a four digit numeric password if this feature has been enabled
in the programming software.
Use the
Menu Key to change fields and the
Read Key to move to the next digit.
After the correct digits are entered, press the
Read Key to proceed to the
programming menu. By default this password is "0200".
• Once you are in the programming menu, you will see the first cap code ready for
viewing or editing. There are four or six cap codes available in total.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for USAlert NP40
Summary of Contents for USAlert NP40
- Page 1 NP40 Numeric Pager Hand Programming Manual • Turn the pager off by pressing the Menu Key. • Using the Menu Key, scroll through the various options until “Pager Off” is found. • Press the Read Key to select this menu item. The pager will then turn off.
- Page 2 • If you do not need to edit the four cap codes, you can press the Menu Key while the ID number is flashing, to scroll through without changing that cap code. • Each cap code can be enabled or disabled if required. “ON” is enabled and “– –“ is disabled.
Need help?
Do you have a question about the NP40 and is the answer not in the manual?
Questions and answers